Fabrication of a micro-tool in micro-EDM combined with co-deposited Ni-SiC composites for micro-hole machining

Jung Chou Hung, Wei Chieh Wu, Biing Hwa Yan, Fuang Yuan Huang, Kun Ling Wu

研究成果: 雜誌貢獻期刊論文同行評審

10 引文 斯高帕斯(Scopus)

摘要

This paper presents an in situ process using a micro-tool in micro-electro-discharge-machining combined with co-deposited Ni-SiC composites to drill and finish micro-holes. During the machining process, a micro-tool is fabricated by wire electro-discharge grinding and electrodeposition. The experimental result shows that the suitable parameters obtained for fabricating micro-tools for Ni-SiC composite coatings are a current density of 7 A dm -2, positive ring hole diameter of 5 mm, SiC particle size of 4 νm, SiC particle concentration of 10 g l-1, rotational speed of 15 rpm and surfactant cetyltrimethylammonium bromide concentration of 150 ppm. When using this method, the micro-tool is provided with a smooth Ni layer, uniform particle distribution and suitable particle adhesion quantity. Then, circular micro-holes are machined in high nickel alloy. Scanning electron microscopy micrographs and atomic force microscopy measurements show that micro-grinding can improve the surface roughness from 1.47 νm Rmax to 0.462 νm Rmax.

原文???core.languages.en_GB???
文章編號013
頁(從 - 到)763-774
頁數12
期刊Journal of Micromechanics and Microengineering
17
發行號4
DOIs
出版狀態已出版 - 1 4月 2007

指紋

深入研究「Fabrication of a micro-tool in micro-EDM combined with co-deposited Ni-SiC composites for micro-hole machining」主題。共同形成了獨特的指紋。

引用此